Picatinny Ring Mount | 25.4mm | Quick Release

This assembly is anodized. Anodizing creates a protective oxide layer on the aluminum surface, providing good corrosion protection and a durable finish. Anodized products can withstand daily use and are resistant to scratches and wear.

Hard anodizing (Type III) provides a thicker and harder layer than standard anodizing and is typically used on products subjected to extra heavy wear.

Installation is simple. The QR base is attached to the Picatinny rail and the scope is placed in the lower ring halves, after which the upper halves are tightened.

Manufacturer's recommendation:
• Tightening torque for ring screws (top, M3.5): 1.8–2.0 Nm
• Tightening torque for attachment to rail (M4): 2.0–2.5 Nm
• Make sure the scope is level and has correct eye relief before final tightening

A torque wrench is necessary for correct installation. Overtightening can damage the scope's tube.

Mounting the scope:Read the guide here

This mount is made from 7075-T6 aluminum – the same alloy used in military equipment, aircraft construction, and high-end climbing gear. 7075-T6 has a strength-to-weight ratio almost twice that of steel and is the preferred material for many professional shooters.

For the vast majority of hunters and shooters, 7075-T6 aluminum is at least as good as steel. The material is lighter, does not corrode, and will withstand decades of use under normal conditions.

Nieload is a manufacturer of Picatinny rails and scope mounts, focusing on precision and quality. They offer rails in both QPQ-treated steel and hard-anodized aluminum, as well as mounting rings in several diameters and heights. Nieload is particularly known for its extensive coverage of Scandinavian rifle platforms.

View all Nieload products: Nieload Collection

The mounting height of rings is typically specified as BH (Base Height) — measured from the top of the Picatinny rail to the bottom of the scope tube (the saddle).

This mount has a fixed mounting height of 4.5 mm (BH).

Rule of thumb: Choose the lowest ring height that still allows free passage between the scope's objective lens and the barrel. A lower mount provides better balance and a more natural sight picture.

These rings have an internal diameter of 25.4 mm (1 inch) and fit scopes with 1" tubes.

Always check your scope's tube diameter before purchasing – it's listed in the scope's specifications or can be easily checked with a caliper.